The XTF-821 is a 10BASE-Te, 100BASE-TX, 1000BASE-T and 2.5GBASE-T transceiver highly integrated into a single monolithic CMOS chip, and is compatible with both the IEEE 802.3 standard and the NBASE-T Alliance PHY. It performs all the necessary physical layer functions for 10BASE-Te, 100BASE-TX, 1000BASE-T and 2.5GBASE-T ethernet over CAT.5e UTP cable. |
The XTF-821 is a 10BASE-Te, 100BASE-TX, 1000BASE-T and 2.5GBASE-T transceiver highly integrated into a single monolithic CMOS chip, and is compatible with both the IEEE 802.3 standard and the NBASE-T Alliance PHY. It performs all the necessary physical layer functions for 10BASE-Te, 100BASE-TX, 1000BASE-T and 2.5GBASE-T ethernet over CAT.5e UTP cable.
The XTF-821 uses advanced DSP technology and an Analog Front End to enable high-speed data transmission and reception over UTP cable. It is a highly integrated solution combining digital adaptive equalizers, ADCs, line driver, echo cancellers, crosstalk cancellers, phase-locked loops and so on. Functions such as Crossover Detection & Auto-Correction, polarity correction are also supported.
Data transfer between MAC and XTF-821 is by the SERDES interface which can be configured as SGMII and 2500BASE-X. XTF-821 operates at multiple digital I/O voltages, including 3.3V and 1.8V.
· Compatible with IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
· Supports IEEE 802.3az (Energy Efficient Ethernet)
· Supports IEEE 802.3bz(2.5GBASE-T)
· Supports Full Duplex flow control (IEEE 802.3x)
· Supports IEEE 802.3 optional ability(Fast Retrain)
· Integrated 10BASE-Te, 100BASE-TX, 1000BASE-T and 2.5GBASE-T IEEE 802.3 Compliant transceiver
· Auto-Negotiation with extended next page capability(XNP)
· Compatible with NBASE-T Alliance PHY Specification
· Supports pair swap/polarity/skew correction
· Crossover detection and auto-correction
· Configurable MDI port ordering(MDI swap) for easy PCB layout
· Supports power down/link down power saving mode
· Supports clause 22 and clause 45 MDC/MDIO management interface
· Supports rate adaptor for SERDES
· Selectable SERDES interface to MAC control(SGMII /2500BASE-X)
· Built-in Wake-on-LAN(WOL) over UTP
· Supports Interrupt function over UTP
· Supports parallel detection
· Baseline Wander Correction
· Supports 3.3/1.8V signaling for MDIO access
· Supports 25MHz crystal or external OSC
· Provides 25MHz clock source for MAC
· Provides 3 network customized LEDs with controllable LED Blinking Frequency and Duty Cycle
· Self-Loopback diagnostic capability
· Supports SPI Flash